Repva

Training to failure and reps in reserve

6 min read, 7 studies cited, updated November 10, 2026

You do lat pulldowns with 60 kg (132 lb). Reps 1 to 8 move at the same speed. Rep 9 is slower and rep 10 is slower again. On rep 11 the bar stops halfway down and won’t move further. Rep 11 was failure. If you had stopped after rep 8, the set would have had 2 reps in reserve.

Failure and reps in reserve

Failure is the point in a set where you can’t complete another rep with good form. Reps in reserve, or RIR, is the number of reps you could still have done when you stopped.

Some lifters rate sets with RPE, a 1–10 effort scale. Zourdos and colleagues (Journal of Strength and Conditioning Research, 2016) tested a version of the scale tied to reps in reserve on 29 lifters doing squats.

RPE Reps in reserve
10 0
9 1
8 2
7 3

Failure and muscle growth

Studies agree that sets need to be hard. They do not show that sets must reach failure.

A meta-analysis by Grgic, Schoenfeld, Orazem and Sabol (Journal of Sport and Health Science, 2022) pooled 15 studies, all in young adults. Muscle growth did not differ significantly between training to failure and stopping short (effect size 0.22, 95% confidence interval −0.11 to 0.55). In the studies of trained lifters, failure had a small advantage (effect size 0.15, 0.03 to 0.26).

A meta-analysis by Refalo, Helms, Trexler, Hamilton and Fyfe (Sports Medicine, 2023) also covered 15 studies. Across every definition of failure the studies used, failure had a trivial advantage for muscle growth (effect size 0.19, 0.00 to 0.37). When the authors kept only the studies that took sets to true failure, the advantage was no longer significant (0.12, −0.13 to 0.37).

Robinson and colleagues (Sports Medicine, 2024) treated closeness to failure as a scale. They estimated the reps in reserve used in each study and found that muscle growth increased as sets ended closer to failure. The authors called the analysis exploratory. The reps in reserve were estimated from each paper’s description of its training and were not measured.

One trial tested the last two reps directly. Refalo and colleagues (Journal of Sports Sciences, 2024) had 18 trained lifters, 12 men and 6 women, train one leg to failure and the other leg with 1 to 2 reps in reserve on the leg press and leg extension for 8 weeks. Quadriceps thickness increased by 0.181 cm in the failure leg and 0.182 cm in the other.

The combined picture is that sets ending within a few reps of failure build muscle, sets ending closer build slightly more, and no study has shown that 0 reps in reserve beats 1 or 2.

Failure and strength

Strength depends less on closeness to failure. The 2022 meta-analysis found no significant difference in strength between failure and non-failure training (effect size −0.09, −0.22 to 0.05). In the studies where the two groups did different amounts of total work, stopping short of failure produced more strength (effect size −0.32, −0.57 to −0.07).

The 2024 meta-regression found that strength gains were similar across a wide range of reps in reserve. A heavy set of 5 that stops with 2 or 3 reps left still trains strength.

What failure costs

A set to failure produces more fatigue than a set that stops short. A meta-analysis by Vieira and colleagues (Sports Medicine, 2022) covered 20 studies and pooled 12. After training to failure, jump height, bar speed and similar measures dropped more, blood lactate rose more and ratings of effort were higher. Creatine kinase, a blood marker of muscle damage, was higher 48 hours later.

Fatigue also lowers the reps on later sets. In the 2024 leg trial, the failure leg lost more reps from the first set to the last than the other leg. In practice a first set to failure might give 12, 8 and 6 reps across three sets, where stopping at 10 might give 10, 9 and 9. Those figures are an illustration. The study reported the loss without them.

How accurate reps in reserve estimates are

A review by Halperin and colleagues (Sports Medicine, 2022) pooled 12 studies with 414 participants who predicted how many reps they had left and then went to failure. On average they underpredicted by 0.95 reps (95% confidence interval 0.17 to 1.73). A set rated as 2 in reserve was closer to 3.

Estimates were more accurate when made near the end of a set, in sets of 12 reps or fewer, and on later sets. Training experience made no measurable difference. The studies varied widely in how they defined failure.

Taking the last set of a machine or cable exercise to failure from time to time shows how many reps you had. That count is a check on your estimates for the earlier sets.

Reps in reserve by type of exercise

These are common ranges that fit the studies above. They weigh the small benefit of going closer to failure against the fatigue and the risk of a failed rep.

Exercise type Examples Reps in reserve
Machines, cables and single-joint lifts Leg extension, lat pulldown, curls 0–2
Compound lifts with dumbbells or machines Leg press, dumbbell press, rows 1–2
Barbell compound lifts for 6–12 reps Squat, bench press, Romanian deadlift 1–3
Heavy barbell sets of 1–5 reps Squat, bench press, deadlift 2–3

A set with 5 or more reps in reserve is closer to a warm-up than a working set. The sets per muscle guide counts a set as hard at about 0 to 3 reps in reserve.

Sets that stop short of failure make it easier to keep the same reps across sets, which is what double progression uses to decide when to add weight. Longer rests have the same effect, as the rest between sets guide covers.

Failing a rep safely

Machines, cables and dumbbells are the safest equipment for sets to failure, because the weight can be put down or let go. A failed barbell squat or bench press leaves the bar on you. For those lifts, set the safety pins just below the lowest point of the rep or use a spotter. Form that changes during a rep counts as failure, even if the bar is still moving. End any set that causes sharp pain.

References

  1. Grgic J, Schoenfeld BJ, Orazem J, Sabol F. Effects of resistance training performed to repetition failure or non-failure on muscular strength and hypertrophy: a systematic review and meta-analysis. Journal of Sport and Health Science. 2022;11(2):202-211. doi:10.1016/j.jshs.2021.01.007
  2. Refalo MC, Helms ER, Trexler ET, Hamilton DL, Fyfe JJ. Influence of resistance training proximity-to-failure on skeletal muscle hypertrophy: a systematic review with meta-analysis. Sports Medicine. 2023;53(3):649-665. doi:10.1007/s40279-022-01784-y
  3. Robinson ZP, Pelland JC, Remmert JF, Refalo MC, Jukic I, Steele J, Zourdos MC. Exploring the dose-response relationship between estimated resistance training proximity to failure, strength gain, and muscle hypertrophy: a series of meta-regressions. Sports Medicine. 2024;54(9):2209-2231. doi:10.1007/s40279-024-02069-2
  4. Refalo MC, Helms ER, Robinson ZP, Hamilton DL, Fyfe JJ. Similar muscle hypertrophy following eight weeks of resistance training to momentary muscular failure or with repetitions-in-reserve in resistance-trained individuals. Journal of Sports Sciences. 2024;42(1):85-101. doi:10.1080/02640414.2024.2321021
  5. Vieira JG, Sardeli AV, Dias MR, Filho JE, Campos Y, Sant’Ana L, Leitão L, Reis V, Wilk M, Novaes J, Vianna J. Effects of resistance training to muscle failure on acute fatigue: a systematic review and meta-analysis. Sports Medicine. 2022;52(5):1103-1125. doi:10.1007/s40279-021-01602-x
  6. Halperin I, Malleron T, Har-Nir I, Androulakis-Korakakis P, Wolf M, Fisher J, Steele J. Accuracy in predicting repetitions to task failure in resistance exercise: a scoping review and exploratory meta-analysis. Sports Medicine. 2022;52(2):377-390. doi:10.1007/s40279-021-01559-x
  7. Zourdos MC, Klemp A, Dolan C, Quiles JM, Schau KA, Jo E, Helms E, Esgro B, Duncan S, Garcia Merino S, Blanco R. Novel resistance training-specific rating of perceived exertion scale measuring repetitions in reserve. Journal of Strength and Conditioning Research. 2016;30(1):267-275. doi:10.1519/JSC.0000000000001049