Repva
Triceps Dip Hold on Bench demonstration

Illustration by RepDB

Triceps Dip Hold on Bench

An isometric hold at the bottom of the bench dip: with your hands on the edge of a bench behind you and your legs out in front, you lower your body and stop with the elbows bent. The triceps work hard at the point where the dip is hardest, with less load on the shoulders than a deep dip on bars.

  1. Sit on the edge of a bench, place your hands next to your hips with your fingers pointing forward and walk your feet out so that your legs are straight.
  2. Slide your hips off the bench and straighten your arms to hold your weight.
  3. Lower your body by bending your elbows until they reach about 90 degrees, keeping your back close to the bench.
  4. Stop there and hold, with your elbows pointing straight back and your chest open.
  5. Keep your shoulders down and away from your ears while you hold for the planned time.
  6. Press up to straight arms and sit back down.

Use a weight and range of motion you can control. These instructions are general guidance.

Primary muscles
Secondary muscles
Front Delts, Chest
Equipment
Bodyweight
Movement type
compound, intermediate
Logged as
Hold
Last reviewed
November 2026

Technique tips

  • Do not drop lower than 90 degrees at the elbow; going deeper puts a lot of stress on the front of the shoulders.
  • Keep your back close to the bench and your elbows pointing back, not out to the sides.
  • Bend your knees and bring your feet closer to make the hold easier.

Log the triceps dip hold on bench in Repva

Repva logs Triceps Dip Hold on Bench as hold, shows last session's numbers beside each set and keeps every record. Free keeps every workout on your iPhone with no account.

Read about the app