Repva
Single-Leg Hip Thrust demonstration

Illustration by RepDB

Single-Leg Hip Thrust

A hip thrust done on one leg: with your upper back resting on a flat bench and one foot planted on the floor, you drive your hips up until your body is level, holding the other knee raised. Working one side at a time isolates the glute and shows up any difference between the legs.

  1. Sit on the floor with your back to a flat bench and rest your upper back against its edge, just below your shoulder blades.
  2. Plant both feet flat on the floor with your knees bent, then lift one knee toward your chest and keep it there.
  3. Keep your chin tucked toward your chest and your arms resting along the bench.
  4. Drive through the heel of the planted foot and push your hips up until your body is level from your shoulders to your knee.
  5. Squeeze your glute at the top without arching your lower back, then lower your hips under control.
  6. Complete the planned repetitions, then switch legs.

Use a weight and range of motion you can control. These instructions are general guidance.

Primary muscles
Secondary muscles
Quads, Hamstrings, Glute Medius
Equipment
Flat Bench
Movement type
compound, intermediate
Logged as
Weight & reps
Last reviewed
November 2026

Technique tips

  • Keep the planted shin close to vertical at the top so the glute, rather than the hamstring, does most of the work.
  • Do not let your hips twist toward the lifted leg; keep your pelvis level throughout.
  • Anchor the bench against a wall so it cannot slide, and start with the two-leg hip thrust until the movement is smooth.

Log the single-leg hip thrust in Repva

Repva logs Single-Leg Hip Thrust as weight & reps, shows last session's numbers beside each set and keeps every record. Free keeps every workout on your iPhone with no account.

Read about the app