Repva
Single-Leg Hip Thrust Hold demonstration

Illustration by RepDB

Single-Leg Hip Thrust Hold

A held top position of the hip thrust on one leg: with your upper back on a bench and one foot on the floor, you lift your hips until your body is flat and keep the other knee raised. Holding it loads the glute of the working leg through the full contraction.

  1. Sit on the floor with your back to a flat bench and rest your upper back against its edge, just below your shoulder blades.
  2. Plant both feet flat on the floor with your knees bent, then lift one knee toward your chest.
  3. Keep the other foot planted under that knee and your chin tucked toward your chest.
  4. Drive through the planted heel and push your hips up until your body is flat from shoulders to knee.
  5. Keep your ribs down and hold the top position for the planned time.
  6. Lower your hips under control and repeat on the other leg.

Use a weight and range of motion you can control. These instructions are general guidance.

Primary muscles
Secondary muscles
Quads, Hamstrings, Glute Medius
Equipment
Flat Bench
Movement type
compound, intermediate
Logged as
Hold
Last reviewed
November 2026

Technique tips

  • Do not arch the lower back at the top; finish the lift by squeezing the glute rather than thrusting the ribs up.
  • Keep the working shin close to vertical so the glute, not the hamstring, does most of the effort.
  • Anchor the bench against a wall so it cannot slide as you push.

Log the single-leg hip thrust hold in Repva

Repva logs Single-Leg Hip Thrust Hold as hold, shows last session's numbers beside each set and keeps every record. Free keeps every workout on your iPhone with no account.

Read about the app