Repva

How to warm up for heavy sets

6 min read, 7 studies cited, updated November 10, 2026

Your first working set today is a squat at 100 kg (220 lb) for 5 reps. If you walk in, load 100 kg and go, the first set will feel heavy and stiff, and you won’t know whether your knees or back are having an off day until you’re already under the full weight. A short warm-up addresses both problems in about 10 minutes.

The warm-up has two parts. A few minutes of general movement gets you warm. Then a handful of lighter sets, called ramp-up sets, build to your working weight.

General warm-up

Spend about 5 minutes on a bike, a rower or a brisk walk, until you feel warm and your breathing picks up a little. Then do a few moves that match what you’re about to lift:

  • Before squats or deadlifts, do 10 bodyweight squats and some leg swings.
  • Before bench or overhead press, do 10 arm circles each way and 10 push-ups.

The evidence for the general part is mixed. A meta-analysis by Fradkin, Zazryn and Smoliga (Journal of Strength and Conditioning Research, 2010) covered 32 studies across many activities and found that warming up improved performance on 79% of the measures examined. In lifting, Abad and colleagues (same journal, 2011) tested 13 trained people on a leg press one-rep max. Adding 20 minutes of easy cycling before the ramp-up sets raised the result by 8.4% on average. Ribeiro and colleagues (Perceptual and Motor Skills, 2014) had 15 men do 4 sets to failure at 80% of one-rep max on bench press, squat and arm curl. Total reps were the same with no warm-up, ramp-up sets, cycling or both. A general warm-up matters most on days with a near-maximal lift.

You don’t need a long stretching routine before lifting. A review of 106 studies by Kay and Blazevich (Medicine & Science in Sports & Exercise, 2012) found no meaningful loss of strength or power after static stretches held under 45 seconds and a likely loss after holds of 60 seconds or more. A review by Behm and colleagues (Applied Physiology, Nutrition, and Metabolism, 2016) put the average loss at 1.1% for holds under 60 seconds per muscle and 4.6% for longer holds. Keep any static stretch before lifting under 60 seconds per muscle.

Ramp-up sets

Ramp-up sets start with the empty bar and climb toward your working weight in three or four steps. The weight goes up and the reps go down:

  1. Empty bar for 8–10 reps.
  2. About 40% of your working weight for 5 reps.
  3. About 60% for 3 reps.
  4. About 80% for 1–2 reps.

For a 100 kg working set of squats, that looks like this:

Set Weight Reps Share of working weight
1 20 kg (empty bar) 10 20%
2 40 kg 5 40%
3 60 kg 3 60%
4 80 kg 2 80%
Working sets 100 kg 5 100%

That’s 20 warm-up reps in total, and only 2 of them are heavy. Rest a minute or less between the first three sets, while you load plates. Rest 1–2 minutes after the 80 kg set before your first working set.

Round to whatever plates you have. If your working weight is 85 kg, 35 kg, 50 kg and 70 kg are close enough.

These percentages are common practice. No trial has compared one ramp-up scheme against another. A systematic review by McCrary, Ackermann and Halaki (British Journal of Sports Medicine, 2015) covered 31 upper-body studies and found strong evidence that warm-ups using heavier loads improve strength and power, which supports building up toward the working weight.

Each step also works as a check. If the 60 kg set feels much heavier than usual, or something pinches, you’ve found out before the heavy sets instead of during them.

That check is the practical reason to ramp up. Research has not shown that warming up prevents lifting injuries. A review of 5 randomised trials in sport by Fradkin, Gabbe and Cameron (Journal of Science and Medicine in Sport, 2006) found fewer injuries with a warm-up in 3 trials and no difference in 2, and concluded the evidence was insufficient either way. McCrary’s review found no study of upper-body warm-ups and injury at all.

How heavy should the last warm-up be?

About 80% of your working weight, for 1 or 2 reps. That’s heavy enough that 100 kg doesn’t feel like a shock, and light enough that it doesn’t take anything out of you.

If you’re working up to something heavier than usual, such as a single at 90% of your one-rep max, add one more step. Your one-rep max, or 1RM, is the most weight you can lift for a single rep. For that kind of day, do a single at about 90% of the target before the attempt.

Fewer warm-ups for later exercises

Your first heavy lift needs the full ramp. Later exercises need less, because you’re already warm.

  • A second exercise for the same muscles. After squats, one set of leg press at about half your working weight for 8–10 reps is enough.
  • A heavy lift for different muscles. If you bench after squatting, still ramp up, but shorter. For a 60 kg bench: empty bar × 10, 40 kg × 5, 50 kg × 2.
  • Light weights. The closer your working weight is to the empty bar, the fewer steps you need. For a 40 kg overhead press, empty bar × 10 and 30 kg × 3 is plenty.
  • Small isolation exercises. For curls, lateral raises or pushdowns, one easy set of 10–12 with a light weight is enough, and often you can skip it.

Keep warm-ups from tiring you

A warm-up set should never feel hard. A few habits keep them light:

  • Let the reps fall as the weight rises. Doing 10 reps at 80 kg before a 100 kg set of 5 turns the warm-up into an extra working set.
  • Stop every warm-up set well short of failure. Each one should feel quick and easy.
  • Keep the rests short early on and longer only before your first working set.
  • Don’t count warm-ups as working sets in your weekly set count.

If your first working set feels worse than your last warm-up suggested, you probably did too many reps on the way up. Cut a step or drop a few reps next time.

Setting the rack

Your empty-bar set is the time to set the safety pins for squats and bench, just below the lowest point of the lift, before the weight gets heavy. If a warm-up set pinches or feels wrong, lighten the working weight or skip that lift for the day.

References

  1. Fradkin AJ, Zazryn TR, Smoliga JM. Effects of warming-up on physical performance: a systematic review with meta-analysis. Journal of Strength and Conditioning Research. 2010;24(1):140-148. doi:10.1519/JSC.0b013e3181c643a0
  2. Abad CC, Prado ML, Ugrinowitsch C, Tricoli V, Barroso R. Combination of general and specific warm-ups improves leg-press one repetition maximum compared with specific warm-up in trained individuals. Journal of Strength and Conditioning Research. 2011;25(8):2242-2245. doi:10.1519/JSC.0b013e3181e8611b
  3. Ribeiro AS, Romanzini M, Schoenfeld BJ, Souza MF, Avelar A, Cyrino ES. Effect of different warm-up procedures on the performance of resistance training exercises. Perceptual and Motor Skills. 2014;119(1):133-145. doi:10.2466/25.29.PMS.119c17z7
  4. Kay AD, Blazevich AJ. Effect of acute static stretch on maximal muscle performance: a systematic review. Medicine & Science in Sports & Exercise. 2012;44(1):154-164. doi:10.1249/MSS.0b013e318225cb27
  5. Behm DG, Blazevich AJ, Kay AD, McHugh M. Acute effects of muscle stretching on physical performance, range of motion, and injury incidence in healthy active individuals: a systematic review. Applied Physiology, Nutrition, and Metabolism. 2016;41(1):1-11. doi:10.1139/apnm-2015-0235
  6. McCrary JM, Ackermann BJ, Halaki M. A systematic review of the effects of upper body warm-up on performance and injury. British Journal of Sports Medicine. 2015;49(14):935-942. doi:10.1136/bjsports-2014-094228
  7. Fradkin AJ, Gabbe BJ, Cameron PA. Does warming up prevent injury in sport? The evidence from randomised controlled trials? Journal of Science and Medicine in Sport. 2006;9(3):214-220. doi:10.1016/j.jsams.2006.03.026